Pages: 1 ... 8 9 [10]
 on: November 12, 2015, 07:20:41 PM 
Started by vaulter - Last post by wisconsinjoker
Are you that guy that used to do a 720 and a HUGE front flip? I was all kinds of depressed when that stopped happening.

 on: October 28, 2015, 03:06:19 AM 
Started by nickp - Last post by nickp
That what I thought, I researched epoxy and found a suitable one and need to sort it now

THe company I bought the board from sorted me out with a replacement Jobe Supanova 2016 due to the prophecy been damaged in transit and I did a deal on buying the damaged prophecy too

So 2 boards for less than a new board, just a bit of gluing to do now🍻

 on: October 27, 2015, 11:49:19 PM 
Started by nickp - Last post by rrkyle
Sand, Prep, Epoxy, Clamp, Sand, Go Ride! 8)

 on: October 12, 2015, 10:34:34 AM 
Started by nickp - Last post by nickp
I have a Jobe Phrophecy 2015 but the edge has been bashed and there is a little delamination between the layers

I'm thinking I could inject some adhesive into the area and then clamp it till it sets

Any recommendations to which type of waterproof glue to use

 on: September 28, 2015, 10:15:19 PM 
Started by Doug - Last post by Razimbom
Searching for information to study a lot.


 on: September 28, 2015, 06:46:46 AM 
Started by teamruby - Last post by Razimbom
Yes, it is a very good message.


 on: September 23, 2015, 09:13:21 PM 
Started by vaulter - Last post by vaulter
Grew up in Plymouth but  Skied in Badgerland ski shows in the waukesha area for years.

 on: September 10, 2015, 01:45:57 AM 
Started by waterdork88 - Last post by Zesagiji
Where can I go for more information.

 on: September 10, 2015, 01:45:12 AM 
Started by etakk7 - Last post by Zesagiji
Yes, it was the right thing anyway.

 on: September 09, 2015, 05:58:35 AM 
Started by Michael Bradshaw - Last post by pinkdialog
Read this story may benefit more or less. But ultimately, Each man has the know of it, of course.


Pages: 1 ... 8 9 [10]